午啪啪夜福利无码亚洲,亚洲欧美suv精品,欧洲尺码日本尺码专线美国,老狼影院成年女人大片

1、WINDOW FILM CONSTRUCTION METHODS AND PROCESS太陽隔熱膜施工工藝及過程1、 Preparation at the construction site 1、在施工現場準備1.1 Determine construction areas according to construction drawings and make preparation of construction in teams. 1.1 確定建筑面積按施工圖紙，并在團隊中的施工準備。1.2 Determine material stacking and blanking location2、s. 1.2確定材料堆放和下料位置。 1.3 Check construction tools and safety measures, such as ladder safety etc.1.3 檢查施工機具和安全的措施，如梯子安全等， 1.4 Further make preparation for protection and prevention.1.4 進一步做好保護和預防的準備2、 Construction methods2、施工方法2.1 Glass cleaning 2.1 清潔窗戶Check whether there are any dirty marks such as 3、soil dust, paints orsilicone glue on glasses before spraying and wetting glasses. Use scouring pad to remove the dirt as necessary and clear away the dust with brushes. Spray washing and installation liquid on the whole glass, and use the cleaning scouring pad to clean the whole window glass. Use th4、e clean dish cloth to clean the window frames.在噴濕窗子之前，先檢查玻璃上是否有泥塵、油漆、或硅酮膠等污物。必要時用刀片將污物清除，然后用硬刷把塵埃掃去。將整快玻璃噴上清洗安裝液，然后用清鏟刀將整個窗玻璃刮鏟。用一塊柔軟的毛巾擦洗窗框四周，把窗框邊緣擦洗干凈。2.2 Window film preparation2.2 準備窗膜Currently three common methods are used to prepare window film.目前有三種常用的方法準備窗膜2.2.1 Method 1: Use other glass as 5、the backer. 方法1：以其他窗戶為墊板，Use a piece of glass that has been cleaned initially as the backer, sprinkle water on the window and place the window film to be installed on it. The protective film of the window film shall be placed towards yourself. 先找一個初步清潔的窗子做墊板，在窗上灑水后，把將要安裝的窗膜置于其上，窗膜的保護膜面向自己。2.2.2 Meth6、od 2: Reversal roll method 方法2：反轉卷軸法Roll the window film reversedly towards the box side carefully, with the protective film facing upwards. The rolling diameter of window film shall be about 2.5cm. While about 8cm long window film is left after rolling, cut the film along the box edge. Grip the rol7、led window film at hands, and then start to tear protective film. Tear the film carefully, and roll the protective fill towards the roll core. Spray installation liquid to glue it and prepare for installation.細心地將窗膜以保護膜向上的方式反卷至盒邊，窗膜卷徑應約為2.5cm。當窗膜卷剩8cm時，在窗膜的前后噴清洗安裝液。把卷好的窗膜握在手中，然后開始撕下保護膜。小心地撕，讓保護層卷向卷軸8、。在撕下保護膜的8cm范圍，將清洗安裝液噴灑在安裝膠上，接著把窗膜卷暫時放置于一干凈之處。2.2.3 Method 3: Double-person installation method 方法3；雙人安裝法One person will clean the window, and the other person will measure windows and prepare window films. When one person stretches the window films out of the box to appropriate length, the other per9、son can cut the window film. After having separating the protective film of the window film a little form the top of window films, staff A grips two top corner of the window film and staff B tear the protective film slowly and spray the washing and cleaning liquid on the installation glue at the sam10、e time. Staff B can continue spray washing and spraying liquid on the glass window and then staff A can install the window film on to the window glass.其中一人先清潔窗戶，而另一人則度量窗戶和準備窗膜。當一人把窗膜從盒中拉出至適當長度時，另一人可以把窗膜切下。把窗膜的保護膜從窗膜上端分開少許后，工作人員甲握住窗膜兩個頂角，由乙則慢慢地把保護底膜撕下，同時在安裝膠上噴灑清洗安裝液。乙可以繼續在玻璃窗上噴灑清洗安裝液，之后甲可以把窗膜鋪帖到窗玻璃上。11、2.3 “Final washing” before installation 2.3 鋪帖前的“最后清洗”Spray cleaning and installation liquid evenly on the whole glass to form a layer of mist, and use the rubber wiper strip to scrape the window glass from the window top through S-shaped motion. Be very careful to avoid leaving any dust mark on the12、 glass while start dragging the scraping mop after it pauses. 將清洗安裝液均勻地在整面玻璃上噴灑一層薄霧，用普通刮擦拖把由玻璃的上方以連續的橫向動作掛擦窗玻璃。在掛擦拖把停頓后再開始拖動時，要格外小心，以免在玻璃上留下塵埃痕跡。2.4 Installation of window films2.4 鋪帖窗膜Spray a proper amount of installation liquid on the whole glass except 5cm range on the top. There shall be no dry 13、places where no installation liquid is sprayed, or the window film will stick too early during installation, which will make you fail to slip the window film to appropriate positions. 除了最頂端的5cm范圍之外，將整面玻璃均勻地噴上適量清洗安裝液，玻璃上不能有沒有噴到的地方，否則安裝時窗膜會太早黏住，使你無法將窗膜滑向適當?shù)牡胤健?.5 The first water squeezing2.5 擠壓水份Spray14、 the washing and installation liquid on the film surface. Starting from the top in the middle of the window film, move the tough squeezing plate upwards, downwards, leftwards and rightwards, and use the same pressure and angle and overlapping motion to squeeze the whole glass, or there will be water15、 stain be left. Pay attention that no water squeezing is conducted within the 5cm range from the sides.再度向?qū)χ覂?nèi)的膜面噴灑清洗安裝液。由窗膜中上方開始，上下左右地移動堅硬擠壓拖把，用相同的壓力及角度、重疊的動作擠壓整塊玻璃，否則將會遺留水漬。2.6 Cutting the side window film2.6 裁切邊部窗膜Use a pentagonal guide plate to stand over the glass vertically, and then use the b16、lade to cut four sides of the window film. The sides of window film must be cut before final squeezing operation. 將一個五邊行導板垂直地立于玻璃上，或以一個你感到自然的角度豎立，然后用刀片裁切窗膜的四周，留下約1mm的邊。一定要在最后的擠壓操作前把窗膜邊部裁切完畢。2.7 Final squeezing 2.7 最終擠壓 安裝液對膜的表面Spray washing and installation liquid on the film surface again. Squeeze 17、water within the remaining 5cm range from inside to outside of the window film, and use the same pressure and angle and overlapping motion to squeeze the whole glass, or there will be water stain be left.再度向?qū)χ覂?nèi)的膜面噴灑清洗安裝液。擠壓在從內部范圍外的剩余5cm窗膜的水，用相同的壓力及角度、重疊的動作擠壓整塊玻璃，否則會有水漬留下。2.8 Squeezing of side areas18、2.8 邊部吸水Use scrap-free towel to wrap the pentagonal guide plate or Teflon plate. Then starting from the position that is 15cm away from the window frame, squeeze the water between the glass and window film with a table force, and carry out the process of water release and sucking. Because the towel 19、can absorb water, change the positions continuously for absorb excess water completely and prevent the gravel from scratching the window films. 用無屑紙巾包住五行導板或特富龍板，由距窗框15cm左右開始，以平穩的力度，將留在玻璃與窗膜間的水份擠壓出來，進行“放水”與“吮吸”工藝。由于紙巾可以吸水，應該不停地轉換位置以求將多余的水分吸盡，同時防止沙礫刮花窗膜。2.9 Window cleaning2.9 窗戶的清潔While all windows ar20、e installed with window films, spray a small amount of cleaner on the window glasses to remove installation liquid and other remainders. Use dry towels to wipe the window glasses to make the windows clean, smooth and glossy. 當所有的窗戶都裝好窗膜后，將少量不含阿摩尼亞的清潔劑噴灑于窗玻璃上，以清除安裝液及其他殘留物。用干的紙巾擦拭窗玻璃，令窗子清潔、光滑明亮。2.10 I21、nspection of visual quality 2.10 檢查視覺質量Observe the glass surface from the point which is 60cm away from the observation point from the appropriate angle of view and under good natural light. The side area of 50mm range from the edge must be deducted from the observation area. Observe whether there a22、re dusts, particles, hairs and fibers, gum spots, bubbles, water frog (obscurity), stria and abrasion, visual deformation of thin films, jagged edge and notches, tilting at the edge and tearing within the observation area. 在室內合適的視角和良好的自然光下，從室內離觀測點60cm處觀測玻璃表面，觀測區域應除去離邊框50mm的邊部，在觀測區域內，觀測塵埃、顆粒、頭發與纖維、膠斑、指印、氣泡、水霧（朦朧）、線痕和擦傷、薄膜視覺變形、折痕、邊部鋸齒狀和缺口、邊部翹起、戳破。